#RADIAL PRORMP MANUAL#

I'm sure you've already checked the connections.Įdit: Added Quantum out spec and emphasized output level.

#RADIAL PRORMP MANUAL#

Don't know where to point you, other than the manual or tech support.īTW, my ProRMP XLR connector could have a tighter fit. It's likely to have an operating level setting or some kind of output level adjustment. The Quantum specifications show a max output level of +18dBu. I'm not familiar with the Quantum, but as mentioned in the above post(s), definitely make sure the output operating level is set to +4dB. I have the ProRMP's 'output level' control backed-off from the max and set around noon. Probably could run the average level even lower. Plug and play easy to use, just connect the ProRMP between the recorder and your amp and adjust the level to suit All the impedance matching is taken care of. The peaks are usually in the single digits. The Radial ProRMP is a 100 passive reamper that lets you to take a pre-recorded track and re-amplify it through a guitar amp or effects pedals to create new and exciting tones. I have used a wide range of DI'd average levels in StudioOne - with signals in the '-' high teens, anywhere from -20dB to -15dB. Here are some thoughts:ĭefinitely good that you have balanced out from the Quantum to the ProRMP. I can usually match the guitar vs ProRMP levels at the amp really closely. I also have a Radial ProRMP, and have not experienced the same issues with low levels. Is the Quantum set for those output levels'? Where can I verify that level is set correctly? Now when you say that 'The RMP is expecting +4 dBu as well coming towards it. PresonusAaron wroteI am currently using a balance TRS to XLR to the Reamp box. Even with a balanced lead if the Studio One-reamp level is way down maybe you are tracking too quietly and need to record louder. An unbalanced lead may be messing up the RMP input impedance as well. After adjusting the control on the RMP both levels should be very close.Ī proper balanced lead from Quantum to the RMP will add 6 dB of signal level compared to an unbalanced connection. Then connect the re-amp pedal from Studio One and play the guitar track you have recorded. plug your guitar directly into the amp and set for a modest level or basic overall level. Radial Engineering ProRMP Reamper (x1) - The Radial ProRMP - affordable Reamping for every studio 129.99 Value Mogami 10-foot CorePlus 1/4' Instrument Cable MCP GT 10 (x1) - The Mogami CorePlus MCP GT 10 is a 10-foot TS to TS Mogami Cable made with W3368 Instrument cable. I assume it is already.Ĭheck as per the instructions as well. Is the Quantum set for those output levels. The RMP is expecting +4 dBu as well coming towards it. I would be using a TRS balanced lead from either the main out or one of the other line outs from the Quantum to an XLR male connector to go into the preamp pedal. It is transformer isolated and provides the right input impedance to match the output impedance from the Quantum. It takes the high level line level signal from your interface and drops it down to guitar levels suitable for an amp.

The Radial ProRMP is a passive re amping box. The DI is not actually required in the re-amping process.

Radial prormp